Rod Pin Crusher of Adhesives / Sealants

As is well known, Rod Pin Crusher of Adhesives / Sealants This product technology has received extensive attention from the industry.

There are usually two classification wheels: metal and ceramics, for some magnetic pollution-sensitive materials, the ceramic grading wheel must be used, and the current market is commonly used in the market. Another silicon nitride ceramic has excellent machining properties, high temperature resistance, corrosion resistance, wear resistance, high strength, high adhesion, low density, low friction coefficient and self-lubricity.

The grading wheel can be widely used in powder refining and grading industries. At present, the maximum diameter of φ180 mm is currently reached, the highest operating speed is 12,000 rpm, and the normal service life is more than 1 year. It has been successfully applied to Downstream users, the application is good. The maximum use of this classification wheel is to prevent metal pollution, in addition, its specific graviz is 40% lower than zirconia ceramics, which can not only greatly reduce the energy consumption of the motor, but can greatly lower motor energy consumption. Under existing motors, overcons can be achieved to obtain finer particles.
ALPA Quartz Sand Rod Pin Crusher of Adhesives / Sealants Case Sharing: This customer needs to be air flow grading to quartz sand, compared to a number of powder equipment manufacturers, and finally pass the experiment, finally choose our alpa grading. Machine equipment. Product particle size: D95: 45μm hour Yield: 8-12T Welcomes major quartz sand manufacturers to visit, incompetent experiments.

Let's talk about how to correctly use Rod Pin Crusher of Adhesives / Sealants

1. Prepare before booting, attachment machines, pipes, and valves, whether it is intact, whether it can be normal Work.
Second, open

1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several turning wind turbines, cyclone separators discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can be adjusted by grading wheel frequencies and charging.
Third, the order of shutdown is: inverter - feeder - Main valve - Compressor - Stepper wheel Motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor.
4, repair

1. The motor should be lubricated regularly, but the grease should not be too large and the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.
4. After the filter bag, you should clean or replace it.
V. Note

1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.

Welcome everyone to continue to pay attention to our website to learn more!