Turbo Grinder for Cerium Zirconium

With the development of society and the needs of life, the demand for Turbo Grinder for Cerium Zirconium is getting bigger and higher, and the requirements for fineness, purity and pass rate are increasing. In the current market, there is a great development space.

Turbo Grinder for Cerium Zirconium is based on the size of the powder particle size, the specific gravity is different, and the settlement speed in the gas is different. The classifier, cyclone separator, dust collector, and the introducer make a set of hierarchical systems. Under the action of fan pulleys, the material is moved at a high speed, and the up airflow into the grading area. Under the action of the powerful centrifugal force generated by the high-speed rotation grading turbine, the coarse, fine particles are separated, and the fine particles that meet the particle size requirements by the gap of the grading wheel blades or the dust collector are collected. After the crude particles are partially fine particles, the velocity along the wall to the secondary air is disappeared and reduced.

The strong washing effect of the secondary wind, the thick particles are separated, and the fine particles rise to the secondary level of the secondary level, and the crude particles reduce the discharge port.

ALPA Chemical Pigments Turbo Grinder for Cerium Zirconium Case Sharing: The company is a company specializing in research and development, production and sales of high-performance organic pigments. In its production process, it needs to be used. Pigment ultrafine pulverization equipment. The company's ultrafine crushing equipment is from our AlPa, which uses our company's Turbo Grinder for Cerium Zirconium.

Technical parameters:
Finished particle size: 10-45μm
Production capacity: 300kg

Inspection work before debugging:

1, new When the installed device, when the equipment is connected and labzed to the warehouse, it is inevitable that foreign matter such as iron block, welding head, welding slag is residual. In the absence of the fan and the main motor, open the implicit baffles under the feed port, allowing impurities and washing materials to be discharged from here. After the end, open the ultrafine pulverizer observation door, check whether there is impurities in the pulverizer, hammer head and ring gear have problems.
2, before checking everything is normal, the power-on starting the device, check the direction of rotation of all motors.
3. Parameter inspection setting for the two inverters of the ultrafine pulverizer's feed motor and the graded wheel motor, check if the air open, contactor, heat relay, overcurrent relay adjustment is appropriate? Return all lines all over again.
4, check whether the solenoid valve is blown normally, regulate the dust collector solenoid pulse width and blow interval.
5. Check if the cleaning of the turbine under the brake dragon has a leakage, you can use your hand or fine powder to have a feeling of suction in the interface, if you have a sealing treatment.After all of the above tests are normal, prepare the material production.

Welcome everyone to inquire!