Turbo Mill of Alumina Powder

Modern production not only pursues production and finished product quality, but also develops toward environmental protection. Especially in the crushing industry, the overall development trend of Turbo Mill of Alumina Powder technology in China is to develop stable and high quality and high quality.

When Turbo Mill of Alumina Powder screen material, under the pressure of the rotating duct, the screen has good commonity. At the same time, under the gravity of the air blower, the screen collects the qualified material, and automatically discharges the material in the front cavity of the valve body by the unloading valve. The raw material powder driven by the compressed air is continuously supplied to the pulverizer without a rotating member. By accurate control of the airflow into three products: F fine powder, m powder and G coarse powder, and collected in subsequent cyclone dust collectors and dust collectors.
The material is driven by the blower of the airflow pulverizer. The lower end of the pulverizer is moved upward to the pulverization region, the strongest, and the strongest effluent is separated under a high speed rotary pulverized turbine. The fine particles that meet the particle size requirements are entered into the cyclone or dust collector by the gap of the pulverized wheel blade. After collecting, some of the thick particles of the fine particles disappear and drops along the cylinder wall to two air ports. The crude particles and fine particles are separated by strong purification of the two winds, and the fine particles rises twice as the grade region, and the crude particles fall to the discharge exit.

ALPA Sulfate Turbo Mill of Alumina Powder case Share: This customer is a Saudi company, you need to grade the potassium sulfate super fine powder, and investigate the international powder equipment company, and finally chose our alpa. classifier device.

Ultrafine Turbo Mill of inspection before commissioning Alumina powder:
1, newly installed equipment, when the equipment in place and pulverizing vessel is connected, will inevitably residual iron, welding head, welding slag and other foreign matter. In the absence of the fan and the main motor, open the implicit baffles under the feed port, allowing impurities and washing materials to be discharged from here. After the end, open the ultrafine pulverizer observation door, check whether there is impurities in the pulverizer, hammer head and ring gear have problems.
2, before checking everything is normal, the power-on starting the device, check the direction of rotation of all motors.
3. Parameter inspection setting for the two inverters of the ultrafine pulverizer's feed motor and the graded wheel motor, check if the air open, contactor, heat relay, overcurrent relay adjustment is appropriate? Return all lines all over again.
4, check whether the solenoid valve is blown normally, regulate the dust collector solenoid pulse width and blow interval.
5, the following Crone brake check whether there is leakage airlock phenomena, or fine powder may be placed in the hand feeling of the presence or absence of the interface inside the suction, ifSealing treatment must be performed.After all of the above tests are normal, prepare the material production.