Multiple Classify Wheel Classifier Xanthan gum

my country's overall development trend is the reverse development of low cost, high efficiency, strong power, strong dispersibility, quality and stable, etc., for various types of ultrafine pulverized equipment Higher technical requirements are put forward. Multiple Classify Wheel Classifierxanthan GUM Engineering Technology will need more and more high-purity ultrafine powder, and ultrafine powder technology will play an increasingly important role in high-tech research and development. Although high purity ultrafine powder is prepared by chemical synthesis, high cost is too high, very difficult for industrial production. The main means of obtaining the ultrafine powder is still mechanical and pulverized, and ultra-fine pulverization technology is a combination of many technologies, and its development also depends on the progress of the related technologies. Therefore, the main development trend of ultrafine crushing equipment has the following aspects to develop fine classified equipment with ultrafine pulverized equipment. Ultrafine pulverized equipment with low energy consumption, small land, and has high processing skills. Integrated development of equipment and process research. Ultra-fine and supporting equipment must adapt to specific bored features and product indicators, and the scale model must be adapted.

Multiple Classify Wheel Classifierxanthan GUM Working Principle: Passive fine powder is delivered to the hierarchy of the upper part of the pulverizer through the rising gas stream. The classifier classifies the qualified material and enters the cyclone collector (if a product having several particle size is required, add a plurality of vertical turbine grace machines). Fine tails are delivered to the bag dust collector via airflow. After filtration, the tail enters the exit of the lower part of the filter and empty the air. Main components of this unit: classifying machine, grinding, grading, synchronous completion, adjusting the speed of the classifier by frequency conversion speed, can adjust the product fineness. For example, if a machining process requires a number of granular sections of the product, then two to four can be increased on the basis of a standard classifier, so that the machine becomes a "two five" machines.

In the production process, the temperature rise of the bearing must be often checked, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to rule out the fault. When the new machine is running, the transmission belt is easy to elongate, pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt. If you want to check, you should replace production quality and production in time. Blades, the bush is often checkedWear, if the wear is worn, the productivity is lowered, and the particle size is replaced by the thickness of the thickness. The host and the grading flow bearing are lipids, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the outer space space in the bearing cavity. Do not fill the grease. Otherwise It will cause too high of the bearing temperature. The spiral feeder has changed the lime than half a year, and the calcium-based grease is added. In the output shaft E, ie the pulley E, avoiding heavy hammer, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-z7-degree anti-motor oil pressure oil, and the deceleration machine is used 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.