2021-12-28 10:56:44
Cell Mills for Silica Flour is good, only need to be produced in a smooth ground place, and low noise, which can avoid dust leakage during the pulverization process, which is favored by the powder industry.
Cell Mills for Silica Flour:
Using high pressure airflow with a self-crushing, ensure the purity of the material, facing individual hardness, high materials, can be used as a crushing of high hardness The cavity, greatly reducing the wear of the material on the pulverizer to ensure that the purity of the material is low temperature and low temperature, and the inert gas can be pulverized, such as nitrogen, carbon dioxide, is suitable for high activity, flammable and explosive non-metallic mine powder.
High capacity, fast efficiency; compared with other ultra-fine pulverizations of the same capacity, because of the continuous feed of Cell Mills for Silica Flour, continuously pulverized, continuous recovery, the characteristics of continuously improvement, With the mode of automation control, the advanced level is much higher than other devices.
The structure is simple, the disassembly and cleaning is convenient, there is no need to lubricate oil, etc.
The product is fine, the particle size distribution is uniform, and the grading effect of Cell Mills for Silica Flour makes it produced by ultrafine powder fineness and distribution, and then cooperate with Cell Mills for Silica Flour. Use more to make the product particle size and distribution far better than the processing of other equipment.
Technical parameters:
Finished particle size: lithium cobaltate small particles D50: 3-6 μm; lithium cobaltate large particles: 50: 8-20 μm; Trimetimeterials D50: 6-13μm;
Production capacity: Lithium cobaltate small particles: 250kg of lithium cobalt acid lithium large particles: 500kg ternary: 500kg
1. If a lubricating oil is added to the rotating section, if the bearing and the shaft are relieved, the bearing will be adjusted; if the bearing wear is impeded, the bearing will be replaced.
2. There is also noise during the pulverization.The cooling sleeve can be used to reduce the temperature, which can allocate water in the crushing chamber.
3. Install a muffler on the fireplace of the crushing room.
4. Resistance equipment, such as using damping boards.
The equipment market is rapidly changed. At present, the airflow classifier has certain needs in the market, but the society is constantly evolving, no matter what industry needs to keep pace with the times, they can lead the industry..
