Rod Pin Mills for Kaolin

We all know that Rod Pin Mills for Kaolin is a very strong airflow crushing equipment. Many stubborn hard materials will be cut into a uniform block of shredding,

Rod Pin Mills for kaolin works in the working temperature increases, when the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.

Technical parameters:
Finished particle size: lithium cobaltate small particles D50: 3-6 μm; lithium cobaltate large particles: 50: 8-20 μm; Trimetimeterials D50: 6-13μm;
Production capacity: Lithium cobaltate small particles: 250 kg of lithium cobalt acid lithium large particles: 500kg ternary: 500kg

1. First, the gap of the hammer screen can be adjusted: the friction on the screen changes varies from the distance between the material and the screen, and the friction is different. Improve the hammer speed and hammer material efficiency by adjusting the hammer net gap. However, during the production process, the screens they use are different, the raw materials are different, the hammer screening gap needs to be adjusted; in the crusher, the crusher is not very good at the beginning, but after a period of time Work, the particles inside the crusher also changes; in the grinding machine parts, the hammer head is easily worn, and the gap between the hammer head and the screen is increased, and the yield is also declining, it is difficult to maintain.
Of course, in order toTest a certain crusher's production, for some of the materials, for some screen holes, in order to determine suitable hammer sieve gaps and suction, no matter how very polishing efficiency data in a short time regardless of the useful life of the screen and hammer . However, in the production of feed grinding, such specific measurement data, according to the operator's work experience, the technical content of the crusher itself is two things. People with enrichment of experience and labor experience also require higher operating costs. When the hammer is worn, the gap between the hammer and the sieve increases, the friction is reduced, and the abrasive efficiency is lowered.
2. Rod Pin Mills for Kaolin mainly requires a reasonable use of reverse glitch: mainly to rush the side hair of the screen into the inside, greatly increase the friction, but this method is not used for a long time. After the globi polishing, the efficiency is lowered. It lasts for 30 minutes to 1 hour.
3. Put the friction piece into the Rod pin Mills for Kaolin: The friction sheet has the effect of the material ring, but the effect is limited. First, the teeth of the friction plate are in front of the hammer head, the friction surface is small, and the hammer is long-lasting; if the sieve area is too small, the output screen area will be reduced.
For any device, everyday maintenance can be performed, to ensure that the equipment can operate for a long time, so daily is critical to the maintenance of ROD PIN MILLS for Kaolin.

If there is a need for Rod Pin Mills for Kaolin and the question, please contact us AlPa,