Impact Mill of EPVC

Impact Mill of EPVC is a very common and common pulverizer. It has a wide range of applications involving many industries.

Impact Mill of EPVC has a small size, light weight, high efficiency, no dust, clean, easy to operate, and aesthetics. The pulverized tank and the blade are manufactured by stainless steel. It can complete the crushing and fine powder in 3 seconds - 2 minutes. It can quickly crush a variety of Chinese herbal medicines and most of the food, wide and wide, and different nature materials can be very smashed. Loss, smash different materials will not be stronger. Such as Western ginseng, ginseng, three seventh, placenta, flyer, pearl, white peony, green beans, soy, sesame, rice, corn, etc. The host and the grading flow bearing are lipomatic lubrication, using special lipids, the replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the interior space in the bearing cavity. Otherwise, It will cause too high of the bearing temperature. The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease.

ALPA Composite Powder Impact Mill of EPVC Case Sharing: The customer is a renewable resource company that requires the selection of different particle size sections of the composite powder, and ultrafine powder less than 30 μm is required. Investigate a number of domestic grading equipment manufacturers, did not find the right equipment, and finally found the right equipment in our AlPa, and selected our vertical grading machine equipment. Product particle size: D97 ≤ 30μm hour yield: 80T
Welcome major composite powder manufacturers to visit, incompetent experiments.

1. Preparation before departure. Check if the host, connector, pipeline, and the valve are normal, working properly.
2, open the machine

(1) Open the compressor power supply, the dust collector pressure valve and the main air valve, open the air pulverizer power switch, and turn on the power switch.

(2) From zero, gradually adjust to the specified speed.

(3) Open the fan, cyclone separator, dust collector, charge motor, open the total power box, set the inverter frequency, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.

3, the sequence of stops:

inverter-feeder-main air valve-compressor-grade impeller-motor cyclone material, dust removal switch-fan-main power supply-air compressor .

4, Maintenance

(1) The motor should be lubricated regularly, but the lubricating oil should not excessively avoid the bearing temperature.

(2) Check the wear situation of the impeller, the screw conveyor and the crushing nozzle.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag, it should be cleaned or replaced.

5. Precautions

(1) When the discharge equipment is run, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric chance are damaged.
(3) Regularly check the safety valve to ensure safety.

Users who need to purchase airflow pulverizer, air flow mill, ultrafine pulverizer, eddy current pulverizer, medical gas flow crusher, ultrafine pulverizer, cone mixer, Chinese medicine crusher, etc. Can contact us.