Pin Grinder for Celecoxib

PIN Grinder for Celecoxib as a clean, efficient, high-level, high-yield of advanced crusher models in crushing, is very extensive, from a few of dozens of micro-test test to several hundred A few tons of large production, PIN Grinder for Celecoxib With its narrow particle size distribution, the average particle size is fine; the powder is good, the product is purity; suitable for low melting point, thermal drugs; good sexy, less pollution; Crushing - Mix - Dry Online Operation and other major characteristics have been widely recognized by the company.

The principle of PIN Grinder for Celecoxib job is to use high-speed airflow to cause the material itself to collide, and the airflow has caused material for the shear effect of material impact, the impact of material and other components and shear. It becomes more pulverized, and the particle size distribution is narrower. Although in certain areas, Pin Grinder for Celecoxib has an unlimited advantages, but it also has a shortcomings that feel a headache, that is, energy consumption is relatively high. The principle has passed the precipitation of time and multiple applications, which is more mature, and has been widely used in mineral materials, chemical materials, pharmaceuticals and other industries.

ALPA Battery Materials PIN Grinder for Celecoxib Case Sharing: Shandong Yantai Chemical Materials Company, PIN Grinder for Celecoxib, who has purchased a specially crushed battery material from our company in 2020. Technical parameters finished particle size: D50: 8-12μm production capacity: 50kg / h

Check before debugging:
1, newly installed equipment, stand in place When the crushing warehouse is connected, it is inevitable that the iron block, welding head, welding slag and other foreign matter. In the absence of the fan and the main motor, open the implicit baffles under the feed port, allowing impurities and washing materials to be discharged from here. After the end, open the ultrafine pulverizer observation door, check whether there is impurities in the pulverizer, hammer head and ring gear have problems.
2, before checking everything is normal, the power-on starting the device, check the direction of rotation of all motors.
3. Parameter inspection setting for the two inverters of the ultrafine pulverizer's feed motor and the graded wheel motor, check if the air open, contactor, heat relay, overcurrent relay adjustment is appropriate? Return all lines all over again.
4, check whether the solenoid valve is blown normally, regulate the dust collector solenoid pulse width and blow interval.
5. Check if the cleaning of the cleaners under the brake dragon has a leakage, can be placed in the interface with the hand or fine powder, there is a feeling of suction, if there is a sealing treatment. After all of the above check is normal, accurateSpare material production.