2021-12-14 08:56:36
Due to the widespread use of Turbo Mill for Blast Furnace Slag, the research and development of classified machines at home and abroad attaches great importance to the research and development of classified machines at home and abroad. In the current market, there is a great development space.
Turbo Mill for Blast Furnace SLAG mainly after accelerating compressed air or inert gas, using high-speed elastic fluid (300 to 500 m / s) or overheating steam (300 ~ 400 ° C) energy, Between the particles, between the gas and the particles, the particles and the wall and other components produce strong impact, shear, collision, friction, etc., at the same time, under the action of the airflow rotation, or with the classifier, Make the thick particles to achieve ultra-fine pulverization. Turbo Mill for Blast Furnace SLAG is a common preparation method of pharmaceutical powder, which is suitable for antibiotics, enzymes, low melting points, and other thermal drug pulverization. With the continuous advancement of ultrafine pulverization technology, it will play an increasingly important role in the pharmaceutical industry.
ALPA crystal sorbitol Turbo Mill for Blast Furnace SLAG case Sharing: Taiwan's cosmetics requires a large amount of crystal sorbitol, through our company, ALPA agent, learned that our company can crush The equipment is customized. After many incident experiments. I finally purchased a company Turbo Mill for Blast Furnace SLAG.
Finished particle size: 10-200 mesh
Production capacity: 10T
Turbo Mill for Blast Furnace SLAG Switch When there is oil pollution, it is timely clean
Turbo Mill for Blast Furnace Slag has been exchanged an essential equipment in the field of industrial manufacturing. It is not only the advantage as a common production equipment. Sometimes Turbo Mill for Blast Furnace Slag will also be damaged. Let's take a look at how to check the repair equipment.
Daily maintenance Turbo Mill for Blast Furnace Slag To check the power outlet, plug, the power cord is no oxygen, the break, if you do not have a power test machine, when the motor is powered, When the handlight movement is rotatable, it can be concluded that there is a capacity failure in the two start capacitances of the machine. If you can make a discharge spark and have a sound, it can be used by the capacitor; ifThe spark and sound are weak, indicating that the capacity of the capacitor has dropped, and it is necessary to change the new or add a small capacitor. The airflow pulverizer does not use this method if the capacitor has damaged the short circuit, and it must be replaced with the same size new product.
In addition to Turbo Mill for Blast Furnace Slag, there is also a rod mill high-speed pulverizer. This crusher general quality is very difficult to damage, while daily maintenance is more important, the following is this Maintenance focus of the gas current pulverizer. Check if the lubrication of the bearing is good to check if all fasteners are tight. Check if the drive belt is installed correctly and the situation is good. Check if the protective device is good. If the protective device is found, it should be excluded in time. Check that there is no material or other debris in the damage chamber, if it is sometimes cleaned. Check if the hydraulic starting machine head or the starting roof rod is returned, the adjustment space is installed correctly and compact.
The Turbo Mill for Blast Furnace Slag manufacturers have knowledge of daily maintenance and maintenance of products.
For more consultation, please continue to pay attention to us, or inquire.
Previous: Rod Pin Grinder of SLAQ
