Ring Roller grinder of pole piece

In this economically flourished area, many people know that Ring Roller Grinder of Pole Piece, crusher technology is in a leading position in the same industry.

Under the action of the high-speed rotary impeller, the gas pressure flowing through the impeller increases, and the high pressure airflow flows out of the impeller, the fine particles are ejected. Since the blade of the rotary vane is designed as a bending, the inlet is large, the exit cross-sectional area is small, so the airflow pressure at the outlet is reduced, the speed increases, and the rotational flow is conducive to classification.
The grading point adjustment mechanism sets three adjustment rods and keeps its synchronous motion using the chain. When the adjustment rod moves up, the fine powder increases; when the adjustment rod moves down, the fine powder is reduced. The graded point can be continuously adjusted, and the granularity of the Ring Roller Grinder of Piece is steplessly adjusted. The gradular weight product can reach D97 ≤ 3 ≤ 150 microns, suitable for fine grading of dry micrometer products.
The setting of the control ring is to ensure that the control ring is formed between the control ring and the radial particles ring, and the stability of the airflow flow is controlled. The residual windlet inevitably introduces excess gas from the dry material, the temperature of the classification chamber is high, and the air can expand, and therefore designed a residual tightening to maintain the stability and balance of the graded indoor airflow.


ALPA airgel Ring Roller grinder of pole piece case sharing: This customer is a high-tech enterprise in R&D, production and sales of nano-energy, fireproof, and insulated new materials, its production The ultrafine pulverizer needs to be used in the process, and the multi-party examine finally purchased our AlPa Ring Roller Grinder of Pole Piece.
Technical parameters:
Finished granularity: D90: 15-30μm

Ultra-microflu Roller Grinder of Pole Piece's correct usage:
1, ultrafine pulverizer and power unit should be installed firm. If the ultrafine pulverizer is fixed, it should be fixed on the cement; if the pulverizer is a mobile operation, the unit should be installed on the base made of angle iron, and ensure the power machine (diesel or electric motor) and the pulverizer The belt wheel groove is in the same turning plane.
2, after the pulverizer is installed, check the fastening of the fasteners of each part, if there is loose to tighten. At the same time, check if the leather belt looseness is appropriate.

4, do not casually replace the pulley to prevent the transition chamber to produce explosion, or the speed is too low to affect the work efficiency of the pulverizer.
5
6. At any time, you should pay attention to the operation of the pulverizer, and the feed should be evenly charged to prevent blocking, do not have a long time overload.If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.

The company has consistently follows the standard management, puts the quality in front of the production and service policy, and provides products and services to customers with confidence and weighing airflow crushers.