Pin Mills Of Air-Foam Rubber

With the continuous development of pulverizer technology, Pin Mills of Air-Foam Rubber has gradually penetrated into people's daily lives.

PIN MILLS OF AIR-FOAM RUBBER:

Using high pressure airflow with animal material to smash it, ensure the purity of the material, facing individual hardness, high materials, high hardness ceramic corundum As the pulverizing chamber, the wear of the material to the pulverizer is greatly reduced, ensuring that the purity of the material is low temperature, or the inert gas is pulverized, such as nitrogen, carbon dioxide, is suitable for high activity, flammable and explosive non-metallic mine powder.

High capacity, fast efficiency; compared with other ultra-fine pulverizations of the same capacity, because of the continuous feed of Pin Mills of Air-Foam Rubber, continuously pulverized, continuously collecting characteristics make it smashed Improve, re-cooperate with the mode of automation control, so that its advanced degree is much higher than other devices.

The structure is simple, the disassembly and cleaning is convenient, there is no need to lubricate oil, etc.

The product is fine, the particle size distribution is uniform, and the sub-effect of the Pin Mills of Air-Foam Rubber has excellent the ultra-fine powder to produce it, and then cooperate with Pin Mills of The use of Air-Foam Rubber makes the product particle size and distribution far better than the processing of other equipment.

A electromechanical company is mainly committed to production of push-fire furnace, roller furnace, mesh furnace and other products. Equipment, products are widely used in new energy batteries, electronic components and other fields. The company has always adhered to the principle of \"people-oriented, innovation first\". The company has established a good relationship with multiple international companies. With exquisite technology, we will have our customers' support and trust. We will give back to our customers with quality products and services to make better contributions to electromechanical needs.
Case parameters:
Product particle size: D50: 15μm
Hour yield: 600kg

1, during production, must be checked The temperature rise of the bearing, when the temperature rise exceeds 50 ° C, should be closed, and the reason is to rule out the fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3Quantity and production.
4, the blade, the bushing should often check the wear situation. If the wear is worn, the productivity is lowered, and the particle size is replaced after the particle size is replaced.
5, the host and the graded flow bearing are lipids, and the No. 2 special lipids are used 265-295.
6, the replacement period of the bearing is 2000 hours, and the amount of the grease is filling the amount of the space in the bearing cavity (episode) or 3/4 (lower test) cut, not too much to fill the grease, otherwiseThe bearing temperature is too high.
7. The spiral feeder has been changed during the change of the lipid of 4,000 hours, and the calcium-based grease is added.