Rod Pin Mills of polyacrylate

Rod Pin Mills of polyacrylate is one of the commonly used ultra-fine pulverization methods, widely used in ultra-fine pulverization or fine pulverization of materials such as non-metallic mine, chemical, chemical, metallurgical and other industries, with a fine particle size, narrow particle size distribution, The surface of the particles is smooth, the particle rules, high purity, and high activity.

A rod pin mills of polyacrylate is high, if you want to use Rod Pin Mills of Polyacrylate for a long time, please pay attention to the following:

1. During the production process, Temperature rises in the bearing frequently, when the temperature rise exceeds 50 ° C, the examination should be stopped, find out the cause, and troubleshoot.
2. When the new machine is running, the transmission belt is easy to eliminate, so it should be noted to adjust the appropriate tightness of the belt to ensure the life of the belt.
3. Test and timely replacement of vulnerable parts should be performed in time to ensure quality and production.
4. The wear of the blade and bushing should be continuously checked. If the productivity is lowered, the particle size is thick after wear, and the wear is immediately replaced.
5. ROD PIN MILLS OF POLYACRYLATE The main and level score bearing is lubricated with special grease (265-295 degrees).
6. The replacement period of the bearing is 2000 hours, and the amount of oil filling of the bearing chamber gap is 1 ≤ 2 (try) or 3 ≤ 4 (try), if it is not too much, the bearing temperature Will be too high.
7. The replacement period of the spiral feeder is 4,000 hours, and ordinary calcium based grease is added. Standard operation to exchange for longer use of airflow crushers.

The above is a seven-point introduction to the daily maintenance of Rod Pin Mills of Polyacrylate.



ALPA desulfurizer ROD PIN MILLS OF POLYACRYLATE Case Sharing: The company is a high-tech company that requires a desulfurizer crusher, investigating a number of fine powder equipment manufacturers at home and abroad. Finally, I chose our AlPa Rod Pin Mills of Polyacrylate.
Technical parameters:
Finished particle size: 200 mesh 90% passed
Production capacity: 4-5T

In general, there are some sounds in operation. Rod Pin Mills of Polyacrylate will definitely have broken sounds during crushing raw materials, which is normal. But if the soundIt turns into noise if the sound becomes too loud.So how do I solve the phenomenon of excessive noise?Let's take a look at it.
1. Add a lubricating oil on the rotating part, and adjust the bearing if the bearing and the shaft are; if the bearing wear is resistant, the bearing will be replaced.
2. There will be noise during the pulverization process.The cooling sleeve is dispensed in the crushing chamber, which can be used to reduce the temperature.
3. Install the muffler on the fireplace of the pulverizer.
4. Damping equipment, such as using damping boards.

As a three-year powder engineering equipment manufacturer, Shandong Alpa has more than 3,000 customers at home and abroad, and the rich research and development experience has always led to the front end of the industry, so before consulting, you need to provideCharacteristic information, printing and export granular parameters, production yield range, purity requirements, specific process requirements (anti-high temperature, explosion-proof, dust pollution, etc.), professional engineers provide corresponding fit equipment models or system solutions.Welcome to inquire.