Hammer Grinder for Sugar Cane

It is well known that this product technology of Hammer Grinder for Sugar Cane has been widely valued by the industry.

The pulverizer is almost no increase in the temperature during the pulverization process, so the thermal material can also be pulverized. The pulverizer has a reasonable structure, stable operation, low energy consumption, large crushing capacity, small size, no fault, easy to clean and maintenance. General shells use water cooling and their own air volume, conveying crushing materials, improves temperature, and reduces thermal materials.

The wear of the blade is caused by the vibration of a large number of ultrasonic eddy currents and high frequency pressures generated by the blade. Compact, no dust, no dust.

ALPA Raw Powder Hammer Grinder for Sugar Cane Case Sharing:

Case parameters:
Product particle size: D90: 2-80μm
Hours Yield: 50-80kg
Hammer Grinder for Sugar Cane is widely used, do you know how to use it correctly? The following content hopes to help you.
1. Preparation before departure. Check if the host, connector, pipeline, and the valve are normal, working properly.

(1) Open the compressor power supply, the dust collector pressure valve and the main air valve, open the air pulverizer power switch, and turn on the power switch.

(2) From zero, gradually adjust to the specified speed.

(3) Open the fan, cyclone separator, dust collector, charge motor, open the total power box, set the inverter frequency, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.
3, the sequence of stops:

inverter-feeder-main air valve-compressor-grade impeller-motor cyclone material, dust removal switch-fan-main power supply-air compressor .
4, Maintenance

(1) The motor should be lubricated regularly, but the lubricant does notIt should be excessive to avoid too high of the bearing temperature.
(2) Check the wear of impeller, helical conveyors, and crushing nozzles.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag, it should be cleaned or replaced.
5. Precautions

(1) When the discharge equipment is run, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric chance are damaged.
(3) Regularly check the safety valve to ensure safety.

Different models of milling machine performance, different granularity, different production efficiency, different production and production environment, the price of processing equipment is also different, customers can ask AlPA engineers to purchase appropriateModel and specification, welcome to inquire.