Rod Pin Grinder for peanut peel

With the development of the times, the progress of society, the development of the market is elegant, and more and more manufacturing have to accelerate innovation, some transformations, some continue to improve the technical level of the product, to adapt to the development of the market, Meet the customer's picky requirements. In the case of continuous changes in the market, only constantly innovation, continuously improve your technical level, and constantly improve your own products, in order to make the airflow classifier industry have a broader development space.

The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settle more in the air than in the water. Moreover, the density and viscosity of the air varies with temperature and pressure.
In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine particles are typically taken away by the airflow. In some cases, the raw material is sent to the gas stream into a pulverized device.

It is well known that the load of solid particles in air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration of the solid in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical directions is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverization coal per centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the airflow speed required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.

The ROD PIN Grinder for Peanut Peel has a wide range of crushing, high pulverization efficiency, high pulverization accuracy, accurate cutting particle size, and good stability.
ALPA Water Available Feni50ROD PIN Grinder for Peanut Peel Case Sharing: This customer needsA device that can be superfined on the metal powder.Finally, we purchased our AlPA CSM710-V mechanical grinder.
Technical parameters:
Production capacity: 200-250kg

Let's introduce the Cleaning of Rod Pin Grinder for Peanut Peel:

1, cleaning pulverizerOther parts: Mainly use the outer screw cleaning the grinding machine cover and components.These places can be brushed with a brush and brush with water or detergent when necessary.

The crusher cabin is the crushed box we said.The item is carried out in the crushing bin, so part of the cutting head is the cleaning point.Different jet mills have different functions.We must first understand this before you can get started quickly and use the airflow milling machine correctly.

If there is related requirements, please call us!