Cell Grinder of Diatomite

Cell Grinder of Diatomite as a clean, efficient, high-level, high-yield of advanced crusher models in crushing, is very extensive, from dozens of micro-test test to several hundred With a few tons of large production, Cell Grinder of Diatomite is narrow, the particle size distribution is narrow, the average particle size is fine; the powder is good, the product is purity; suitable for low melting point, thermal drugs; good sexy, less pollution; Crushing - Mix - Dry Online Operation and other major characteristics have been widely recognized by the company.

Cell Grinder of Diatomite is raised in the working fluid, and when the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.

The customer lacks experience in powder grading, but many ultrafine powder is currently required to select ultrafine powder for ultrafine powder. The customer has chosen our ALPA as a partner after investigation. Provide a grading machine device for its customers' ceramic powder production lines.
As a crusher manufacturing large enterprise, Shandong ALPA has been working to provide customers with greater value, the fineness, production capacity and installation site of each project is important information for custom selection, pre-sales service session.
AlPa There are 24-hour online customer service to answer questions, provide an ideal grading machine production line solution, and provide the factory quotation to increase escort for ceramic powder grading projects. Welcome major ceramic powder manufacturers to inquire.

1. Before using the pulverizer, first check whether all fasteners of the machine are tightened and the belt is fastened.
2. The spindle direction must be consistent with the direction of arrow on the shroud, otherwise it may damage the machine and cause personal injury.
3. Check if the crusher is complete.
4. Check if the gas flow pulverizer has a hard object such as metal in a crushing room, otherwise it will damage the tool, affect the machine.
5. You must check the purity of the material before crushing.Metal hard materials are not allowed to avoid damage to the tool or cause combustion.
6. The oil cup on the machine should always note the full lubricant to ensure that the machine is operating normally.
7. Stopping before stopping.If you do not continue, remove the residers from the machine.
8. Regular inspection tools and screens are damaged.If damage is damaged, it should be replaced immediately.
9. There will be slight vibration when using the fuselage.Be sure to tighten the cover to connect the handle to avoid accidents.

Shandong AlPa is a source manufacturer specializing in Cell Grinder of Diatomite. All the year round provides equipment for domestic and foreign customers. Welcome to inquire!