Rotor Crusher of Lithium Hydroxide

Rotor Crusher's balance performance is good, only need to be produced in a smooth floor, and low noise, which can avoid dust leakage in the pulverization process, favored by the powder industry.

Rotor Crusher of Lithium HydroxIDE should be installed in a place where the site is flat.

Before working, it is necessary to pick up the processing material, no metal, stone, etc., the hard substances are mixed into the machine, so as not to damage the parts or failures in the machine. Check that each component is firm and reliable before booting. Everything is normal, the side can turn on the power, idle for 1-2 minutes, check whether the operation is normal, everything is normal, it can be pushed.
When operating, the operator cannot leave. Once the sound is abnormal, the power should be disconnected immediately.

When machining raw new friends Chinese medicine crusher, the discharge opening should be tied to the bag. When the pulverizer is in use, if you encounter the power supply voltage, do not use it, so as not to damage the motor. When the power supply voltage is normal, the machine is not easily damaged, and the production efficiency is high.

Technical parameters:
Finished granularity: 700 mesh
Production capacity: 800kg

In production, a certain number of materials must be maintained in the airflow grinding chamber. In the case where the flow rate of the pulverized gas is not changed, the material in the grinding cavity is large, the gradient current is large, and the material is small in the grinding cavity, the gradient current is small.
In addition, the feeding speed must remain uniform and stable, don't be too fast or too slow.
If the feeding speed is too fast, the device will overload.
Regular maintenance equipment, often check whether the gas supply pressure meets the pressure required, and the airflow mill, the equipment is running 3000 hours, or the long-term shutdown and long-term storage, should be cleaned in a gas flow grinder nozzleAnd the inner wall of the grinding cavity and attached to the material grading portion to prevent the influence of gas flow grinding on the grinding effect.