Cell Mills for coating

Cell Mills for coating This product technology has been widely valued by the industry. Cell Mills for coating is mainly used to determine its wide range of applications, high fine, typical materials: super hard diamond, silicon carbide, metal powder, high purity requirements: ceramic pigment, medicine, biochemistry, medicine. Cell Mills for coating converts the normal gas source from the gas source to inert gas such as nitrogen, carbon dioxide, is an inert gas protection device for use in flammable and explosive, oxidative materials, pulverization, grading, and processing.

The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settle more in the air than in the water. Moreover, the density and viscosity of the air varies with temperature and pressure.
In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine particles are typically taken away by the airflow. In some cases, the raw material is sent to the gas stream into a pulverized device.

It is well known that the load of solid particles in air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration of the solid in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical directions is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverization coal per centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the airflow speed required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.

The cell Mills for coating has a wide range of unclear, high pulverization efficiency, high pulverization accuracy, accurate cutting particle size, and good stability.
AlPA Anhydrous glucose medium Cell Mills for coating case Sharing: A starch sugar is needed to take a decentralized equipment for water glucose media, and some powder enterprises have not found appropriate equipment. We have found appropriate equipment in our AlPA. Our Cell Mills for Coating can disperse the water glucose medium.
Technical parameters:
finished particle size: waterless glucose greater than 18 mesh

Cell Mills for coating temperature high solution
1. Ensure the quality of the crushing machine Hazardous Lubrication: Real-time monitoring system is carried out on a real-time monitoring system, and immediately observe the harm of grinding disc.
2. The grease oil does not meet the regulations: Analysis of the grease on time on time, ensuring that the grease oil exceeds the remarks.

I want to know more product knowledge and continue to pay attention to our website. If you need to purchase Cell Mills for Coating, please feel free to contact us.