Rod Pin Mills for Potassium Permanganate

Rod Pin Mills for Potassium Permanganate As the names is a mechanical equipment applied to the production area, which is mostly used in pulverizing particles, fast pulverity, good precision.

Many of the commissioning process Manufacturers will choose to buy a Rod Pin Mills for Potassium Permanganate, but not all crushers can be applied to production and processing, and the wrong processing method will make the pulverizer wear speed. The mill is wear is too fast, and the inner cavity of the pulverizer of the material should be selected when the material hardness is too large.

The device operates for a long time in a higher crushing pressure, which requires uniformity of cyclical replacement losses.
The product after the crushing products are generally single peaks. If there is a double-peak or multimodal main reason, the pulverization pressure is unstable. The solution is based on the gas supply of gas source equipment to meet the amount of gas required for work, ensuring that the lowest gas supply pressure of the gas is high than the working pressure.
The feed speed is unstable. Solution to check if there is a blockage at the feed valve; the material is not very viscous, uniform liquidity, and the stable control feed speed. A filter cake is formed in the pulverizer chamber. The solution is suspended, and the filter cakes in the crushed chamber will then return to the production.

Technical parameters:
Finished granularity:
100-325 mesh
Production capacity: 5kg

1, Before using it, check all standard parts of the device to tighten, and the belt is tight.
2, the spindle operation direction must conform to the direction of the arrow shown on the protective cover, otherwise it will damage the equipment, and may cause human damage.
3, check the electrical appliance is not intact.
4. Check the hardware such as metal-free materials in the equipment crushing room, otherwise it will damage the tool, affect the equipment operation.
5, the material must be checked before crushing, and there is no metal material hard article to be mixed to prevent crash or cause combustion.
6, the oil cup on the device should often be injected into the lubricant to ensure that the equipment is operating normally.
7. Stop the addition before the stop, if it does not continue to be used, to remove the in the machine.
8. Check the tool with the screen on time is damaged. If it is damaged, it should be replaced first.
9. When using the timing, there is a small oscillation, so it is necessary to connect the handle to the handle to avoid accidents.

The company has consistently follows the standard management, puts the quality in front of the production and service policy, and provides products and services to customers with confidence and weighing airflow crushers.