Cell Mill for Wear-Resistant Materials

With the continuous development of pulverizer technology, Cell Mill for Wear-Resistant Materials has gradually penetrated into everyday life.

Cell Mill for Wear-Resistant Materials has a small size, light weight, high efficiency, no dust, clean, easy to operate, and aesthetics. The pulverized tank and the blade are manufactured by stainless steel. It can complete the crushing and fine powder in 3 seconds - 2 minutes. It can quickly crush a variety of Chinese herbal medicines and most of the food, wide and wide, and different nature materials can be very smashed. Loss, smash different materials will not be stronger. Such as Western ginseng, ginseng, three seventh, placenta, flyer, pearl, white peony, green beans, soy, sesame, rice, corn, etc. The host and the grading flow bearing are lipomatic lubrication, using special lipids, the replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the interior space in the bearing cavity. Otherwise, It will cause too high of the bearing temperature. The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease.

AlPa White Carbon Black Cell Mill for Wear-Resistant Materials Case Sharing: The company is a company engaged in white carbon black production. A ultra-fine pulverization apparatus for producing two granular white carbon products can be generated in the production process. After investigation, we finally purchased our AlPA Cell Mill for Wear-Resistant Materials.

Technical parameters:
Finished granularity: D50: 6.78 D90: 12.8μm
Production capacity: 30kg

Connected to the Cell Mill for Wear-Resistant Materials Blocked Fault Solution, Xiaobian For your opinion, I hope to have some reference to you. Crushes blockage is the most common fault of machinery.

It may be one of the most common failures in mechanical design, but because improper operation can cause many faults.
(1) The feeding speed is too fast, the load is increased, causing clogging. During aquaculture, pay attention to the deflection angle of the current table pointer at any time. If the rated current is exceeded, the motor overload and long-term overload will burn the motor. This should be reduced or closed immediately, but it can also be controlled by increasing the feed speed to control the feed speed. Because the speed is fast, the load is large, the load fluctuates great. Therefore, the current of the rolling mill is generally controlled around 85% of the rated current.
(2) The unloading tube is inserted or the interference is too fast, and the universal crusher is blocked, and the delivery device does not match, resulting in weakening or calm of drainage tube. In order to find faults, we must first clarify the export transport equipment, do not change, adjust the amount of feed.And the normal operation of the equipment.
(3) The water content, aging, screening, crushing and sealing material of the hammer hammer are too high, and the general grinding will be blocked.It is necessary to regularly update the working status of the hammer aging and the serious aging, and check the screen regularly.Improve the production efficiency of universal grinding machines, improve the reliability of non-blocking and grinding.

If there is related requirements, please call us!