Analysis of the cause of the feed port of the mill

The use of milling machines is wide, and they can see them in mining, building materials, chemicals and other industries. In use, generally, the feed port of the mill is inherently suede, but if you find that the feed port is the case of the hair blow, it will show that the device has failed, and it is easy to blow away the blow.

The material has sprayed, which in turn affects the production and quality of the equipment, then what is the cause of this phenomenon?

1, first check whether the two damper of the mill is closed. Because the device uses a circulating wind design, under normal circumstances, the device is to the inner feed port, the discharge port is outward, and if the damper is closed, the air volume cannot be circulated, thereby forming out of flimfall The phenomenon.

2, regularly do the cleanup work of the mill in dust cloth bag, if the dust bag is blocked, then the wind will not be discharged, which will affect the grinding effect of the equipment. There is also a grinding machine to be installed in a ventilated place. If the cloudy sky is more, the air should be cleaned up when the air is particularly wet, and the good exhaust effect should be guaranteed.

3, when the mill is produced, the amount of the grinding material must be uniform, and it cannot be considered. It causes a blurring machine to block, and a vibrating feeder can be configured to feed, which is not only more energy efficient, but can reduce the phenomenon of device blockage.

 4, the milling machine should check the seal of the equipment pipe, especially if there is a phenomenon in the wind door on the equipment shell, if it is resolved immediately, so as not to work in subsequent work. Impact the grinding effect of the mill.