Single Classifying Wheel Classifier ammonium sulphate

With the development of society, the application of Single Classify Wheel Classifieramonium Sulphate has become more large.

Single Classifying Wheel Classifier amonium Sulphate can effectively reduce costs, reduce costs, so applicable to low value platinum powder. And the structure is simple, the maintenance is convenient, because the lifescas are less, the noise is small, and the energy consumption is low. And this classifier does not use the powder box grading wheel structure, more simple operation, more convenient maintenance. So it is capable of improving production capacity. At the same time, its inner wall is also smooth and wear, so it is also more conducive to the grading of materials. In addition, the grading machine is a negative pressure operation, which can make it dry and dust-free to achieve environmental requirements. It is operated stable, good reliability, and the classified product can also be uniform, consistent.

Let's take a look at how to extend the use of Single Classify Wheel Classifierammonium Sulphate:

1. Strictly follow the operating procedures;

2. If you are damaged parts, you should pay attention to time check, timely replacement.

3. The device body has no rotating components, not affected by the lifetime of the bearing. However, due to the difference in powder hardness, the degree of wear is different, especially the wear of the hierarchy knife tip, our body part uses special material production, the use of the knife tip is at least more than one year, the knife tip is wear more than 1 cm or more It will affect the grading accuracy, in order to avoid affecting product quality, it is recommended to contact us to replace the knife tip;

4. It is recommended to use the long filter device to improve equipment stability, and ensure grading accurate.

If you want to make a big performance during the work, the maintenance is not less work. What should be maintained?

1. When cleaning the classifier, you need to pay attention to the motor not to touch Take water, and the shaft is also the same.

2. If you want to change the precision classifier, or if you want to repair, you must be in the case of power failure.

3, usually pay attention to lubrication and maintenance of the bearing of the classifier.

4. If the precision classifier works for 1,500 hours, remember to add lubricant.