FL Multiple-stage Classifier in Series of potassium sulphate

With the development of society, the application of FL Multiple-stage Classifier In Series of Potassium Sulphate has become more large.

Let's take a look at how to extend FL Multiple-stage Classifier In Series of Potassium Sulphate: 1. Strictly follow the operating procedures; 2, easy to damage parts should be paid attention to Today's check, replace it in time. 3. The device body has no rotating components, not affected by the lifetime of the bearing. However, due to the difference in powder hardness, the degree of wear is different, especially the wear of the hierarchy knife tip, our body part uses special material production, the use of the knife tip is at least more than one year, the knife tip is wear more than 1 cm or more It will affect the grading accuracy, in order to avoid affecting product quality, it is recommended to contact us to replace the knife tip; 4. It is recommended to use the long filter device to improve equipment stability, and ensure grading accurate.

Let's talk about how to use Fl Multiple-Stage Classifier In Series of Potassium Sulphate. First, prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it works fine. Second, open 1. On the compressor power supply, the pressure valve and the main air valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power. 2. The zero start classification wheel is gradually adjusted to the specified speed. 3. Turn on the fan, the cyclone separator discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break. 4. The granularity of the finished wheel can be adjusted by grading wheel frequencies and charging. Third, the sequence of shutdown is: inverter - feeder - Main valve - Compressor - Steady wheel motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor. Fourth, repair 1. The motor should be lubricated regularly, but the grease should not be too large, the bearing temperature is too high. 2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable. 3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the pulverization.Effect. 4. After the filter bag is a period of time, it should be cleaned or replaced. 5. Precautions 1. When the discharge device is running, the unloading port cannot be extended to avoid accidents. 2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller and electricity will be damaged. 3. Regularly check the safety valve to ensure safety.