Rod Pin Mills of FRP

With the continuous development of pulverizer technology, Rod Pin Mills Of FRP has gradually penetrated into daily life.

In terms of airflow milling, it is important to understand its operational rules, which is very important because only familiarize the procedure, can operate correctly.
1. The operation rules of ROD PIN MILLS OF FRP are as follows: Prepare materials before the start of the production order before the start of the production order. Complete the site to clean the grocery. Check whether the transportation pipes and auxiliary equipment, whether the pipelines are blocked, leak or poor sealing, whether the auxiliary equipment is intact, whether it works normally. Whether there is a phenomenon that the material is accumulated in the outer casing and the separator, if the accumulated material is required. Whether the bearing is lubricated, whether it is lubricated in an appropriate place. Check if all pipes, fastening bolts, washers, spindles, and instruments are intact, normal and flexible.
Second, ROD PIN MILLS OF FRP starts first starting the motor, controls the current and time at starting, so that the device can start running. When the equipment is operating normally, the feed speed can be adjusted according to the properties of the material. Uniform continuous feed should not be large or small, thereby affecting the separation effect of the grinding machine, making the machine easily malfunction. During operation, if an abnormality occurs, stop checking immediately before the failure continues.
Third, the main procedures of ROD PIN MILLS OF FRP are as follows: After the material is completely pulverized in the grinding machine housing, it should stop the feed and turn off the motor. After the machine is idling for 3 minutes, press the stop button to stop the machine. When the machine is completely stopped, open the check door and check the wear of the vessel. Fill in the corresponding production record, update the device status flag, which is convenient for the next use.


ALPA precipitation method White carbon black ROD PIN MILLS OF FRP case share: The customer is an Egyptian company, from our English official website, we have the superchard of white carbon black Microfin experience. There are a number of cooperative customers. Through the incoming experiment and on-site visit. Determined our AlPA strength, and finally purchased Rod Pin Mills of FRP from our company.

Ultra-micro ROD PIN MILLS OF FRP:

2, after the pulverizer is installed, check the fastening of the fasteners of each part, if there is loose to tighten. At the same time, check if the belt looseness is combined.suitable.

4, do not casually replace the pulley to prevent the transition chamber to produce explosion, or the speed is too low to affect the work efficiency of the pulverizer.
5
6. At any time, you should pay attention to the operation of the pulverizer, and the feed should be evenly charged to prevent blocking, do not have a long time overload.If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.


Today, the knowledge of Rod Pin Mills Of FRP will introduce you to here. If you want to know more, please continue to pay attention to our website.